The use of a Residual Current
•
Device (R.C.D.) with a tripping
current of not more than 30mA
is recommended. Even with an
R.D.C. installed, 100% safety
cannot be guaranteed and
safe work procedures must be
obeyed at all times. Do a
check of your R.C.D. each
time you use it.
Immediately disconnect from
•
the mains if the power cord is
cut or the insulation is
damaged.
Do not touch a cut or
•
damaged power cord until the
electrical supply is
disconnected.
Do not repair a cut or
•
damaged power cord. Replace
it with a new one.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
For model LC 141iV, LC 141i:
•
To prevent accidental start
during maintenance, turn the
safety key to 0 and remove the
battery. Wait at minimum 5
seconds before you start the
maintenance.
For model LC 141C: To
•
prevent accidental start during
maintenance, disconnect the
power cord.
919 - 003 - 23.10.2019
Do the maintenance work
•
correctly to increase the
lifetime of the product and
decrease the risk of accidents.
Let an approved service agent
do the professional repairs.
Speak to your nearest service
agent for more information.
Only do the maintenance work
•
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
Put on heavy duty gloves
•
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
Keep the cutting edges sharp
•
and clean for the best and
safest performance.
Let your service agent
•
regularly examine the product
and make necessary
adjustments and repairs.
Replace damaged, worn or
•
broken parts.
Obey the instructions for how
•
to change accessories. Only
use accessories from the
manufacturer.
When not in operation, keep
•
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
17