Additional Information; Dimming The Display; Setting The Sleep Timer; Setting Up The Remote To Control Your Tv - Pioneer HTS-LX 70 Mode D'emploi

Additional information

Chapter 10
Additional information
Important
• Press to set the remote control to receiver
RCV
control mode in order to operate the receiver
subwoofer (make sure that the LCD displays the
RECEIVER screen, as shown below).
RECEIVER
ADV
SURR
SURR

Dimming the display

You can choose to dim the display of the display unit if you
1
find it too bright.
1 Press SETUP.
SETUP
ENTER
2 Select 'System Setup' then press ENTER.
ENTER
3 Select 'Dimmer' then press ENTER.
ENTER
4 Select 'Dimmer Light' or 'Dimmer Dark'
then press ENTER to confirm.

Setting the sleep timer

The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
about it.
SLEEP
• Press to select an option.
Choose between the following options:
• Sleep On – Switches off after about an hour
• Sleep Off – Cancels the sleep timer
After selecting Sleep On, you can press SLEEP again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
S l e e p - - - - -
Note
1 The display of the display unit dims when the sleep timer is set, regardless of this setting.
F.S.
SURR

Setting up the remote to control your TV

You can use the supplied remote to control your TV. To be
able to use this feature you first have to program the
remote with a maker code from the table on the following
page.
1 Set the input to TV.
TV
2 Press and hold the TV button and press SETUP.
The TV preset screen is shown on the remote control, and
the current maker code is displayed on the LCD screen.
TV PRESET
3 5 1
1 2
4 5
7 8
0
CLEAR
3 Use the number buttons to input the maker code
for your TV, and press ENTER.
See the table on the next page for the list of maker codes.
If there is more than one code given for your make, input
the first one in the list.
• If the maker's name of your TV doesn't appear in the
table, you will not be able to use this remote to control
your TV.
4 Point the remote towards your TV and press
 SOURCE to check that the remote works with your
TV.
If the remote is set up correctly, the TV should switch off.
If it doesn't and there is another code given for your
maker, repeat step 1 with a new code.
Maker code
3
6
Number buttons
9
ENTER ENTER
EXIT
10
49
En