Technical Specifications - Bonnet Neve KALEIDO INTEGRAL Mode D'emploi

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
replaced by duly licensed personnel. THE USE OF ADAPTOR PLUGS IS FORBIDDEN.
Make sure that power supply voltage corresponds to the values appearing on the rating plate of the
refrigerator. Consider also that the maximum allowable power voltage variation is +/-6%.
IMPORTANT: THE REFRIGERATOR MUST BE PROPERLY EARTHED. The manufacturer di-
sclaims all responsibility for damage resulting from non-observance of this safety principle. If the
refrigerator must be installed far from the power points, make certain that the connection complies
with the standards in force.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY PERSONAL INJURY OR PROPERTY
DAMAGE ARISING FROM INCORRECT INSTALLATION.

6. TECHNICAL SPECIFICATIONS

The built-in electrical installation is composed of control and safety devices adequately lodged in
the cabinet. The relevant wiring diagrams and part lists are contained in a sealed plastic envelope
together with the present booklet. Keep such documents with the booklet. The technical data,
which are also reported on the rating plate inside the showcase (see fig. 11 on page 19),
are shown in table II, page 18. The sound level generated by the running refrigerator is below
70 dB(A). The refrigerator generates no harmful vibrations.
WE HEREBY DECLARE THAT THE CABINET AT ISSUE COMPLIES AS EXECUTING ECC DIRECTIVE
1935/2004 ON MATERIALS AND OBJECTS FIT FOR CONTACT WITH EDIBLES.
Thermostat adjustment is reserved for the technical after-sales service only.
7. LOADING PRODUCTS
Switch the cabinet on by the wall cutoff switch. As soon as the cabinet is on it will start its cooling
cycle. Allow about two hours before loading any products, which must already be at their preserva-
tion temperature. THE CABINET IS FACTORY-REGULATED FOR THE ANTICIPATED PERFORMANCE.
ATTENTION! Front glazing can be opened for cleaning and restocking operations. It is
advisable to carry out these jobs when the sales area is NOT OPEN TO THE PUBLIC.
When loading products make certain that:
• they are similar in size and type;
• they do not obstruct the flow of refrigerated air (see page 21 - fig. 14).
ATTENTION: maximum load capacity is 90 kg/m2 for the base, 225 kg/m2 for the
shelves, and 10 kg/m2 for the glass top (load capacities also visible from the sections).
8. USE
The KALEIDO INTEGRAL were designed and manufactured exclusively for the display of fresh food
like fruits, vegetables, dairy produce, sausages and fresh meat (CLASSES 3M2). Its function is pre-
serving food temperature, not lowering it. Therefore, when introduced, THE FOODSTUFFS MUST BE
AT THEIR CONSERVATION TEMPERATURE. Do not load foods that have undergone heating.
For best cabinet operation we recommend:
• loading the products as explained in the preceding section;
• do not lay heavy weights on the showcase's top surface (fig. 12).
KALEIDO INTEGRAL
Epta Spa - Unità locale: Via degli Alpini 14 - 32020 Limana (BL)
ITALIA Tel. 0437/9681 Telefax 0437/967434
37/59
PAGE:
UM000490
N° DOC.