Assembling; Rating Plate - CASO DESIGN SJ 200 Mode D'emploi

13.2 Assembling

► The silicon grafting must be inserted into the bottom of the material barrel (residue
outlet) before use, and pulled out before cleaning. See the picture below.
► Disassembly should be done in reverse.
Attention
► The unit only works if the lock cover is installed correctly.
► When using the device for the first time, it may happen that a strange odor is caused by
the engine by operating residues. This disappears with repeated use.

13.3 Rating plate

The rating plate with the connection and performance data can be founded beneath the
device.
Caso Entsafter SJ 200
Please note
Please note
Please note
1. Put the material barrel at the
fixed point of the host and keep it
steady (see Figure 1).
2. Install the pressure auger at
the the material barrel and slightly
press it downwards (see Figure 2).
3. Place the filter screen into
the pressure auger, install it at the
middle of the material barrel and
rotate to latch it (see Figure 3).
4. Install the lock cover on the
material barrel (see Figure 4).
Aligning to the unlocking symbol
, and follow the direction of arrow
to rotate it clockwise to the locking
symbol (see Figure 5 +6).
28