Electrical Connection; Design And Function; Overview - CASO DESIGN SJ 200 Mode D'emploi

 If you do not use the device very often, store it in a dry and well-circulated location to
avoid that the motor getting damp and moldy.

12.10 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.

13.1 Overview

Caso Entsafter SJ 200
1. Lock Cover (with feeding
tube)
2. Pressure auger
3. Filter Screen
4. Material Barrel (with
juice and residue outlet)
5. Host
6. Pressing Bar
7. Brush
8. Juice-receiving Cup /
Residue-receiving Cup
27