Operation And Handling; Before First Use; How To Use; Juicing-Locking-Function Switch - CASO DESIGN SJ 200 Mode D'emploi

14 Operation and handling

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages.
► Do not let the device unsupervised during operation to be able to react quickly in case
of dangers.

14.1 . Before first use

Clean the device, see "cleaning".
► If the pressure auger stops during use, please press and hold the "REV" button 3-5
seconds. The pressure auger rotates in opposite direction. Then press the "ON" button,
the device restarts and the pressure auger rotates again in right direction.
1. For the fruits with hard core, please remove their cores firstly.
2. Stale materials stored in the refrigerator for a long time must be soaked in cold water for
at least 10 minutes before use.
3. Materials must be cut into pieces before juicing.
4. Put food materials into feeding tube and push them down by pushing the pressing bar.
5. Do not put too many materials when juicing, to avoid damage to the filter screen.
6. After juice extraction, turn off and pull out the plug.
► All materials for juicing must be completely fresh.
► Do not use the product to smash grains or extract juice of sugarcanes.
► Do not keep the extracted vegetable/fruit juice for a long time.

14.2.1 Juicing-Locking-Function Switch

► Do not replace any accessory of the product when the product is running.
► Please use this product always on a stable and safe place.
Caso Entsafter SJ 200
Warning

14.2 How to use

ON
OFF
REV
Please note
Please note
Attention
Forward
Stop
Reverse
Move the handle towards the unlocking
direction to discharge residue. Move it
towards the locking direction
discharge drier residues.
to
29