Design And Function; Overview; Assembling - CASO DESIGN PJ 1000 Mode D'emploi

 Make sure that the power cable is undamaged and has not been installed under the
device or over hot or sharp surfaces.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.

13.2 Assembling

1. Place main machine on the table.
2. Place middle ring on the main machine.
3. Place the juicing net carefully on the rotor.
4. Place transparent cover on the middle ring.
5. Clinch residue barrel under the ejection and around transparent cover.
6. Tight and clinch the handle.
7. Push juicer jug over the juicing noozle.
► This device is equipped with a safety lock. When the parts are not locked in properly,
the motor will not turn on.
13.1
1.
2.
2a Feeding port
3.
4.
4a Juicing noozle
5.
5a Rotor
6.
7.
8.
Please note

Overview

Pushing bar
Transparent cover
Juicing net
Middle ring
Handle
Residue barrel
Main machine
Juicer jug
28