Stereo/Double Mono 70V Line; Stereo/Double Mono 25V Line - Focal FLEX POWER 2120 Manuel D'utilisation

flex power
U s e r m a n u a l
d. Stereo/double mono 70V line
To activate the ZONE 1 amplification output at 70V, proceed as follows:
1. Set the MONO selector on the front panel to ON (double mono) or OFF (stereo).
2. Set the "LINE 25/70/100V" switch to ON mode.
3. Connect the loudspeaker cables to the "0V" and "70V" outputs of the SPEAKER ZONE 1 (Left) Euroblock terminal. Make sure the polarity
of the enclosures is correct: the "70V" terminal is the positive pole to be connected to the enclosure's "+" (red) connector, the negative
"0V" terminal to the "-" (black) connector.
4. Repeat operations 1, 2, 3 for the "LINE 25/70/100V" switch and the SPEAKER ZONE 1 (Right) Euroblock terminal.
e. Stereo/double mono 25V line
To activate the ZONE 1 amplification output at 25V, proceed as follows:
1. Set the MONO selector on the front panel to ON (double mono) or OFF (stereo).
2. Set the "LINE 25/70/100V" switch to ON.
3. Connect the loudspeaker cables to the "0V" and "25V" outputs of the SPEAKER ZONE 1 (Left) Euroblock terminal. Make sure the polarity
of the enclosures is correct: the "25V" terminal is the positive pole to be connected to the enclosure's "+" (red) connector, the negative "0V"
terminal to the "-" (black) connector.
4. Repeat operations 1, 2, 3 for the "LINE 25/70/100V" switch and the SPEAKER ZONE 1 (Right) Euroblock terminal.
Warning: to avoid distortions or malfunctions, the sum of the powers distributed in the enclosures composing
the line must be less than or equal to 120 W per channel.
2120
17