Overhead Rigging - Briteq LDP COBWASH WW Mode D'emploi

ENGLISH
IR-REMOTE
Note: Make sure that the IR-remote option in the setup menu is switched on before you start using the
remote control.
1. DIMMER-buttons: you have 4 buttons with presets: OFF
(blackout), 20%, 50% and 100% (full on). After choosing
one of the 4 presets you can further adjust (fine-tune) the
output with the ±buttons (4).
2. STROBE-buttons: you have 4 buttons with presets:
OFF (no strobe), 20%, 50% and 100% of the maximum
strobe speed.
3. NUMBER buttons: used to set the desired DMX
address (5: D-button).
4. ±-Buttons: used to increase / decrease the value of the
selected function.
5. D-button: used to switch the projector to DMX-mode.
6. S-button: used to switch the projector to DMX-mode and
set the DMX-address remotely. Below an example is
shown to set DMX-address "437"
 Press the S-button: output is on.
 Press 1 st
number button (3): in this case button "4"
, the output is off.
 Press 2 nd
number button (3): in this case button "3" , the output is on.
 Press 3 rd
number button (3): in this case button "7" , the output flashes 2 times to indicate that the
new DMX-address is accepted.
7. SA-button: not used for this projector
8. SL-button: not used for this projector
9. Battery compartment: receives a CR2025 3V-battery (supplied).

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device
when installing the unit. This secondary safety attachment should be installed in a way
that no part of the installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The installations should be
inspected every year by a skilled person to be sure that safety is still optimal.
BRITEQ
®
4/50 LDP-COBWASH 50 + 100 (WW/CW)
OPERATION MANUAL