Briteq LDP COBWASH WW Mode D'emploi page 9

ENGLISH
CH. MODE
Used to set the desired channel mode.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 CH:01
master dimmer
 CH:02
strobe + master dimmer
 Once the correct option shows on the display, press the ENTER button to save it.
Remark: on RDM-compatible controllers this option can also be remotely set.
SLAVE MODE
Used to set the projector as slave in a master/slave setup.
 Press the MODE button until SLAVE MODE is showing on the display.
IR-REMOTE
Used to set the wireless remote function on/off.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 OFF
The unit does not accept commands from the supplied remote controller.
 ON
The unit can be controlled by the supplied remote controller.
 Once the correct option shows on the display, press the ENTER button to save it.
MASTER DIM
Used to set the master dimmer while used as master.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired level for the master dimmer. (please note that the last
selected static color will be used to set the value)
 Once you have the desired level, press the ENTER button to save it.
Note: the setting of this option has NO effect while the projector is used as SLAVE or in DMX-mode.
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired curve:
 Once you have the desired curve, press the ENTER button to save it.
LAMP BEHAVIOR
Used to select the reaction time of the projector.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 LED
 HALOGEN
 Once the correct option shows on the display, press the ENTER button to save it.
BRITEQ
®
The projector follows the instructions instantly, no delay.
The projector imitates the behavior of a halogen lamp (slower reaction time).
7/50 LDP-COBWASH 50 + 100 (WW/CW)
OPERATION MANUAL