Overview; Safety Standards - Ariston 3318628 Mode D'emploi

overview

Safety standards

Legend of symbols:
Failure to respect the warnings leads to a risk of injury and
may even lead to death.
Failure to respect the hazard alerts may adversely affect
and damage,seriously in some cases, property, plants or
animals.
************
Install the appliance on a solid wall that will not be
subject to vibrations.
Noisy operation.
When drilling the wall, take care not to damage the
electrical cables or pipes.
Contact with live conductors can cause electrocution. Ex-
plosions, fires or poisoning in the event of gas leaking from
a damaged duct. Damage to existing installations. Floo-
ding in the event of water leaking from damaged ducts.
Electrical connections must be made using conductors
with a suitable cross section.
Fire caused by overheating due to the electrical current
passing through cables that are too small.
Protect connection cables to prevent them from being
damaged.
Contact with live conductors can cause electrocution.
Explosions, fires or poisoning in the event of gas leaking
from a damaged duct. Flooding in the event of water
leaking from damaged ducts.
Check that the part and the installations to which the
appliance will be connected comply with the current
applicable standards.
Contact with incorrectly installed live conductors can
cause electrocution. Damage to the appliance due to
unsuitable operating conditions.
Use accessories and manual equipment suited to the
utilisation (ensure that the tool is not damaged and the
handle is securely attached and in good condition), use
this equipment correctly, protect it against being acci-
dentally dropped and store it after use.
Personal injury caused by projected shards or fragments,
inhaling dust, being hit, or cuts, pricks or abrasions Da-
mage to the appliance or to objects close by caused by
projected debris or fragments, cuts, incisions.
Use the appropriate electrical equipment (in parti-
cular, check that the cable and the power plug are in
good condition and that the rotating or alternating
parts are firmly secured). Use correctly. Do not obstruct
the passage with trailing power cables. Secure these to
prevent tripping. Disconnect and store them after use.
Personal injury can be caused by projected shards or
fragments, inhaling dust, being hit, or cuts, pricks, abra-
sions, noise or vibrations. Damage to the appliance or to
objects nearby caused by projected debris or fragments,
cuts, incisions.
Ensure that portable ladders are stable and sturdy and
will not slip, and that the rungs are in good condition.
Ensure that someone is present to ensure that ladders
cannot move when someone else is using them.
Injury can be caused by falling from a raised height or by
cuts (folding ladder).
Ensure that mobile ladders are stable and sufficiently
sturdy, that the steps are non-slip and in good condi-
tion, and that they have a guard rail running the
length of the ramp and along the platform.
Injury can be caused by falling from a raised height.
When working in height (generally in the event
of use when height differences of more than
2 m exist), ensure there is safety railing surrounding
the working area or that personal equipment is used
that prevents falling, that the route of any potential
fall is nor obstructed with dangerous objects, and that
any possible impact would be cushioned by semi-rigid
or deformable supports.
Injury can be caused by falling from a raised height.
Make sure that the health and safety conditions are
adequate in terms of lighting, ventilation, structural
soundness and emergency exits.
Personal injury caused by being hit, tripping, etc.
Protect the appliance and the areas surrounding the
working area using suitable equipment.
The appliance or nearby objects may be damaged by
shards being projected, cuts or scratching.
Move the appliance using the necessary protective
equipment and the highest degree of precaution.
Damage to the appliance or the surrounding objects as a
result of shocks, impacts, scratching or crushing.
While work is being carried out, safety clothing and
personal protective equipment should be used.
Personal injury can be caused by electrocution, projec-
ted shards or fragments, inhaling dust, being hit, or cuts,
pricks, abrasions, noise or vibrations.
Ensure that all equipment is stored in a way that makes
it simple and safe to handle; avoid creating piles which
are in danger of collapsing.
Damage to the appliance or the surrounding objects as a
result of shocks, impacts, scratching or crushing.
Operations inside the appliance must be carried out
with due care to avoid coming into sudden contact
with sharp parts.
Personal injury caused by cuts, pricks and abrasions.
Reset any safety and control functions affected by an
operation on the appliance, and make sure that they
are operating correctly before it is put back in service.
Explosions, fires or poisoning caused by gas leaks or incor-
rect evacuation of flue gas. Damage to or stoppage of the
appliance due to uncontrolled operating conditions.
Drain any components which may contain hot water,
activate the vents before any operation, where appli-
cable.
Personal injury caused by burns.
Descale components following the recommendations
in the safety sheet for the product used, ventilate the
room, wear protective clothing, avoid mixing products
together, protect the appliance and nearby objects.
Personal injury through skin and eyes coming into contact
with acidic substances, inhalation of ingestion of harm-
ful chemical agents. Damage to the appliance or objects
nearby due to corrosion caused by acidic substances.
If there is a smell of burning or flue gas coming from
the appliance, switch off the mains supply, open the
windows and call a technician.
Personal injury caused by burns, inhalation of flue gas,
poisoning. Explosions, fire or poisoning.
GB
39