Operation
Trigger Setting Diagram
The Net-X II can set recorded scenes to a trigger using the 5-wire Phoenix Connector on the rear of the
unit. Up to 4 triggers can be connected for momentary functionality.
A latching switch will be necessary to run indefinitely.
1
2
3
4
Trigger 1–4 Inputs
Backup
The Net-X II has a backup setting that allows the product to save and load configurations.
1.
Use the knob to select 12. Backup.
2.
Press the knob.
3.
Use the knob to select 1. Save.
4.
Press the knob.
5.
Use the knob to select 2. Load.
6.
Press the knob.
7.
Use the knob to select 3. Exit (to cancel).
8.
Press the knob.
This will backup to the internal memory, and does NOT include the recorded scenes. The use of
the webserver backup method will be needed to backup to an external source.
Firmware Version
This function displays the firmware version of the product.
1.
Use the knob to select 13. Firmware Version.
2.
Press the knob. The firmware version will display: B1.0 V1.6.
3.
Press the knob to exit.
Exit
This function exits out of the menu to the main screen.
1.
Use the knob to select 14. Exit.
2.
Press the knob. The product returns to the home screen.
Net-X II User Manual Rev. 3
Ground Input
TRIGGER 1
TRIGGER 2
Trigger 1–4
labels
TRIGGER 3
TRIGGER 4
Ground label
19