Mounting; Orientation; Rigging; Procedure - Chauvet Professional MAVERICK MK2 SPOT Mode D'emploi

Setup

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.

Orientation

Always mount this product in a safe position and ensure that there is adequate room for ventilation,
configuration, and maintenance. The Maverick MK2 Spot can be suspended upright or upside down using
the two Omega brackets included, or it can be placed on it rubber feet on a flat-level surface.

Rigging

Chauvet recommends using the following general guidelines when mounting this product.
• When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
• Make sure to mount this product away from any flammable material.
• If hanging this product, make sure that the mounting location can support the product's weight. See
the Technical Specifications
• When hanging this product, always secure to a fastening device using a safety cable. For our
CHAUVET Professional line of safety cables, go to http://trusst.com/products/.

Procedure

The Maverick MK2 Spot comes with a double-bracketed yoke to which you can either attach mounting
clamps for hanging or simply use as a floor stand. You must supply the mounting clamps. Make sure the
clamps can support the weight of this product. Use at least one mounting point per product. For the
CHAUVET Professional line of mounting clamps, go to: http://trusst.com/products/.

Mounting diagram

Safety cable
Overhead Mounting
Maverick MK2 Spot User Manual Rev. 11
for the weight-bearing requirements of this product.
Omega bracket
Mounting clamp
Safety Notes.
Floor Mounting
Rubber feet (x4)
Page 6 of 189