Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
NetWork Timeout
The network timeout sets the time delay for the Net-X II to stop receiving commands from a console
connected to the network. This can only be applied to HTP/LTP DMX merge modes via Art-Net™ or sACN
protocols.
1.
Use the knob to select 5. NetWork Timeout.
2.
Press the knob.
3.
Use the knob to select either 1. Disabled, 2. 1 Seconds, 3. 2 Seconds, or 4. 5 Seconds.
4.
Press the knob.
5.
5. Exit (to cancel).
If set to Disabled, the Net-X II will remain locked into the network lighting controller even if the
controller stops sending data.
Set DMX Port
The Net-X II has 8 DMX ports that can be set as outputs or inputs. To select a DMX port to configure, follow
the instructions below:
1.
Use the knob to select 6. Set DMX Port.
2.
Press the knob.
3.
Use the knob to select the desired DMX port, from DMX Port 1–8 / DMX Input A–B (DMX inputs
will only display if Operating Mode is set to 2 + 8 Port), or Exit (to cancel).
4.
Press the knob.
Disp Type
The display type determines whether the selected port universe displays as either decimal or hexidecimal
values. The display type will alter the menu options for Network and Universe ranges.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 1. Disp Type.
3.
Press the knob.
4.
Use the knob to select either DEC (decimal) or HEX (hexadecimal).
5.
Press the knob.
DMX Status
The DMX status determines whether the selected port functions as an input, an output, or is disabled. The
selected status will alter the menu options for DMX Mode and Universe merging.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 2. DMX Status.
3.
Press the knob.
4.
Use the knob to select the desired port mode from, DISABLE, OUTPUT, or INPUT.
5.
Press the knob.
DMX Mode
The Net-X II is capable of merging two signals of the same protocol into one, using HTP
(Highest Takes Precedence), or LTP (Latest Takes Precedence) logic when the DMX Status is set to
Output. When the DMX Status is set to Input, Normal and Backup must be set to the same Output
universe.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 3. DMX Mode.
3.
Press the knob.
4.
Use the knob to select the desired mode:
•
SINGLE (OUTPUT Status only) - Disables Ethernet signal merging.
•
HTP (OUTPUT Status only) - Highest Takes Precedence.
•
LTP (OUTPUT Status only) - Latest Takes Precedence.
•
NORMAL (INPUT Status only) - Input port acts as a primary controller.
•
BACKUP (INPUT Status only) - Input port acts as a backup controller; the Net-X II will NOT
start accepting changes from the backup port until the normal port with the same Universe
assignment stops broadcasting control signal.
5.
Press the knob.
Net-X II User Manual Rev. 3
Set DMX
Port.
Set DMX
Port.
Set DMX
Port.
15
Publicité
Table des Matières
