Operating Settings Configuration; Home Screen; Start Address; Network Setup - Chauvet Professional Maverick MK1 SPOT Manuel D'utilisation

Operating Settings Configuration

Home Screen

The Maverick MK1 Spot has a home screen that shows the protocol mode, the IP address or DMX
address, the DMX personality, and the current product temperature. To see the home screen, press.
<MENU> repeatedly until it appears on the display. On the Home Screen, press one of the menu buttons
to immediately access any part of the menu (e.g., Personality, Starting Address, or Universe) or press the
buttons <ENTER> to access the main menu.

Start Address

To set the starting address, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Start Address, or touch the display where it
says Start Address.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Enter the starting address (001–512) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
5. Press <ENTER>.

Network Setup

The universe of the TCP/IP protocol will be the universe of the DMX function.

IP mode

The IP address of the Maverick MK1 Spot can be set manually, by the network, or to a preset static
address specific to each product. To set the IP Mode, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
• Manual – set the IP address with the control panel
• DHCP – the network sets the IP address
• Static – a pre-set address specific to each product, or touch the display where it says the
desired mode.
7. Press <ENTER>.

Universe

The Universe must be assigned through the product menu. To set the Universe, do the following:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Enter the universe address (000–255) with one of the following methods:
• Type the universe number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the universe or subnet is set as desired.
Page 14 of 191
Home Screen shows on the display. Press <ENTER>.
Home Screen shows on the display. Press <ENTER>.
Home Screen shows on the display. Press <ENTER>.
Maverick MK1 Spot User Manual Rev. 9
Operation