switel WTF 729 Mode D'emploi page 67

Operating the Walkie−Talkies
Transmitting the ringing tone
The ringing tones indicate to other subscribers that you want to talk
to them. A condition for this is that the other subscribers are using
the same channel and CTCSS code.
T
Selecting/Deactivating ringing tones
There are 10 ringing tones available for selection. To deactivate the
ringing tone, select the setting 0" (zero).
3 x M, X/Y, P
Searching for a channel
Signals are searched for in the eight channels in a continuous cycle.
The icon appears in the display. If an active channel is detec-
ted, the channel scan stops. Press the P button to enable radio
communication. If the P button is not pressed, channel search
resumes after five seconds.
Starting/Stopping global channel scanning
To execute a global channel scan", set the CTCSS/CDCSS code of
the output channel to 0 (zero). The scanning routine stops at every
channel on which a signal is received regardless of the CTCSS code
transmitted with the signal.
O
Start/End specific channel scanning
To execute a specific channel scan", set the CTCSS/CDCSS code
for each channel to an individual value.
The scanning routine only stops when a signal is received on a chan-
nel that matches the value set.
O
If a certain channel should be scanned fully during a spe-
cific channel scan", the code must be set to 0 (zero) for
this channel.
Resuming channel scanning
X/Y
Send ringing tones
Select the ringing tone and confirm
Start/End channel scanning
Start/End channel scanning
Resume channel scanning
67