Padded Swing-Away Armrests; Footrests, Legrests, & Footplates - Quickie QXi Manuel D'instructions

Q XI / Q X
2. Flipping Armrest Back and Removing Armrest
a. Depress the release latch (3) and pull arm toward back of wheelchair.
b. to remove, pull up on armrest. Pin securing armrest will automatically release.
c. to return armrest to operating position, push armpad down ( 1 ) until it locks firmly into place.
K. PADDED SWING-AWAY ARMRESTS
swing-away armrests can be detached or can swing away to allow lateral transfers. swing-away, removable
armrests are installed by sliding armrest (A) into receiver (B) on back frame.
NOTE –to avoid armrests that are angled inward or outward when seated in the wheelchair ensure receiver
hardware is mounted onto the frame so that the hardware is perpendicular to the frame thus prop-
erly aligning the armrest when installed into the receiver.
1. Installation
slide armrest into receiver tube (A) on rear of frame.
2. Swinging Away
lift armrest out of locked position and rotate to the side.
3. Removing Armrest
Pull armrest straight out of receiver.
L. FOOTRESTS, LEGRESTS, & FOOTPLATES
Make sure that your sunrise dealer has correctly adjusted your footrests and/or legrests with the advice of a
healthcare professional. the original setup should not be changed without first checking with that advisor.
the footrest position is key to keeping your body in the proper alignment, and providing a stable support for
your legs and torso. legrests and footrests should be swung out of the way, or removed for transfers.
swing-in-swing-out hangers and Footrests (60°, 70º, 80°)
1. Basic Footrest Installation
a. Place swing-in/swing-out pivot saddle into the receiver (c) on front frame tube with the footrest
facing inward or outward from the frame.
b. Rotate the footrest inward until it locks into place on locking plate.
2. Removal
a. to remove footrest, release latch (D) by pulling lever upward or pushing lever downward.
b. Rotate footrest inward or outward and lift.
120346 Rev. D
21
22
23
16
VIII. USE AND MAINTENANCE
1
7
8
6
4
1. Armrest Pad
2. Upper securing lever
3. Release latch
4. outer armpost Armrest Panel
5. transfer bar
6. Rear Receiver
7. Armrest Panel
8. Armrest Release Pin
21
2
5
3
22
23
D