Sonnenkonig GENUA Mode D'emploi page 46

6 Instruction of the remote controller
To use your ceiling fan with the remote controller, puint the transmit-ter to the IR sensor.
ON/OFF: Press to turn on or off the light (on models equipped with)
VENTILATOR OFF: Press to switch on or off the fan
1 : Press to select a low rotation speed
2 : Press to select a medium rotation speed
3: Press to select a high rotation speed
To change the batteries open the housing cover, sliding out the cover downward to
the arrow shown direction while pressing down the cover with thumb. (1.5V/AA,2PCS)
(Fig. 3). Holder for transmitter, if desired, could be installed onto the wall with two screws
(Fig. 4). Make sure the battery housing cover is positioned correctly. Do not leave the
remote control to direct exposure of sunlight. Dispose of used batteries properly using
suitable containers for dis-posal. The batteries are subject to deterioration due to aging,
and should be kept in good condition and free of fouling. If you plan to keep the remote
unused for long periods, remove the batteries and store them in a proper place. Use the
infrared remote control only as indicated on this instructions. The use for other purposes
may cause danger and may invalidate the warranty.
46