Westfalia 300 056 391 101 Instructions De Montage page 27

Installation Instructions:
Electrical System for Towing Hitch
Connecting the back-up light, the brake light and the parking light
21. Connect the back-up light, the brake light and the parking light to the vehicle lines in
accordance with the pin assignment plan and using the supplied crimp connectors.
Pin assignment plan
green 1.0
black/red 1.0
gray/black 0.75
gray/red 0.75
Special information concerning vehicles with parking distance control (PDC)
On vehicles with PDC it is possible to deactivate the PDC system for trailer operation provided
the deactivation is done using a negative signal.
22. Lay the brown/white cable from the trailer module plug (Fig. 1/4) to the PDC controller.
23. Connect the end of the cable to a free connector or to a specific PDC connector.
24. Check the PDC controller using the Service Tester and recode it for trailer operation, if
necessary.
Note
If you have any queries concerning the coding procedure, please contact the nearest
garage.
Checking correct operation
25. Reconnect the ground of the vehicle's battery.
26. Check the trailer function with the help of a suitable test instrument (with load resistors) or
with the help of a trailer.
27. Secure all cables using cable ties.
28. Refit any parts removed for installation.
Universal Elektroanlage
Control line for back-up light
Control line for brake light
Control line for left parking light
Control line for right parking light
300 056 391 101 - 01 33/02 27