Parts Description; Before The First Use - Tristar ST-8063 Mode D'emploi

Instruction manual
• Unplug the appliance from the socket when you are not using it.
• Note: To avoid danger by accidental resetting the thermal protection,
this appliance may not be powered through an external switching
device, such as a timer, or connected to a circuit that regularly will be
switched on or off.
• Make sure that the cord is not hanging over the edge of the table or
counter, does not touch any hot surfaces or is coming directly into
contact with the hot parts of the appliance. Do not place the appliance
underneath or close to curtains, window coverings etc.
• Make sure the cord does not touch the hot parts of the appliance.
* Competent qualified repair service: after sales department of the producer
or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this repair service.

PaRTS DeScRIPTIoN

1. Water tank
2. Burst of steam button
3. Water tank cover
4. Steam ON/OFF button
5. Foldable handle
6. Handle folding button
7. Heat up lamp
8. Temperature control
9. Voltage selector
110V~ or 220-240V~
10. Stainless steel soleplate
4
1
2
3
4

BeFoRe The FIRST uSe

• Carefully read all instructions before using the iron.
• Clean the soleplate with a soft damp cloth before the iron will be used
for the first time.
• Pull out the water tank cover and slowly fill the water tank with clean
cold water using the measuring cup.
• Use a flat-head screwdriver to set the iron to the correct voltage for the
country of use before plugging into the wall outlet.
• Smell or smoke may disperse at the beginning as caused by the
warming up of the insulation material.
uSe
• Ensure the iron is set to the correct voltage for the country of use
before plugging into the wall outlet.
• Lift up the foldable handle, if it is in the folded position.
• Pull out the water tank cover and fill the iron with clean cold water.
Watch the water level in the water tank, do not overfill.
5
• Press the water tank cover firmly to close.
• Slide the temperature control to the appropriate ironing temperature,
6
as indicated on the garment's ironing instructions.
• Rest the iron at upright position and plug into a wall outlet.
7
• The iron can be used after a warm up time of approximately 2 minutes.
8
• Set the steam ON/OFF button to steam, If steam ironing is required.
9
• Press the burst of steam button for strong steam. Burst of steam will
10
not function at low temperature setting.
• When finished ironing, set the temperature control to OFF and turn
steam ON/OFF button to "O". Rest at upright position and unplug the
device.