Witter G120U Instructions De Montage

MATERIALS
A 1 Main Crossbar.
B 1 L/H Sidearm.
C 1 R/H Sidearm.
D 2 M12 x 35mm x 1.75p Bolts, Lock Washers, Washer (30od) & Witter Cage Nut Retainer & M12 Square Nut
E1 4 M10 x 1.5p Nut, M10 Shakeproof Washer & M10 Washer
E2 2 M12 x 35mm x 1.75p Bolts, Shakeproof washer & Nut
F 4 M12 x 35mm x 1.75p Bolts, Lock Washers, Washers & Nut
ZE 1 Flip-Up Electrical Plate Kit
ZN 1 Neck Kit
FITTING
1. Remove the rear light clusters by removing 4 nuts accessed through panels within the boot and then removing one
screw hidden beneath a cover on outer light casing. Unclip wiring and slide lights out.
2. Remove 5 torque screws from around each wheel arch and ease arch trim away from vehicle slightly.
3. Remove 6 plastic plugs from lower edge of the bumper.
4. Remove the bumper, unplugging any wiring connected to it.
5. Remove the bumper beam and the plastic bumper support brackets (return beam to the customer).
6. Assemble cage nuts D to each sidearm B & C (as per separate fitting instruction) then slide side arms down the chassis
and attach loosely using the remaining fixings D. Attach sidearms to rear panel using fixtures E1 & E2.
7. Attach Crossbar A to the sidearms using fixings F (Note that the bolt nearest the vehicle is attached up through the
sidearms).
8. Attach chosen neck option (ZN) and electric kit (ZE).
9. Re-attach plastic bumper support brackets.
10. Fully tighten ALL fixings to their correct torque settings.
11. Refit bumper with the bumper insert removed or with the insert in place but cut as shown.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instructions
µW0001G120U-FIT$011302050000;Ä
W0001G120U-FIT$011302050000
TOWBAR
For Vauxhall Mokka
2012-
G120U