Configuration 1 - Room Probe - Royal DORA AIR Notice D'installation Et D'entretien

8.1

Configuration 1 - Room probe

Configuration 1 is the default configu-
ration for this appliance. In this case it
is not necessary to make any changes.
The appliance leaves the factory with the room
probe already connected to the terminals and
positioned on the rear panel (Fig. 30).
It is possible to place the room probe in another
place to detect the desired room temperature.
Set configuration 1 to switch the appliance on and
off either manually or according to a program.
76
T
Room temperature
probe
The appliance modulates the power according to
the room temperature read by the room probe
placed on the stove itself.
You can set the "Eco-mode" function
to have the appliance switch off or on
again according to the room tempera-
ture set.
The antifreeze function can also be set in this
configuration.
It is important to check that the appli-
ance is set to Configuration 1.
This configuration can also be used to switch
the appliance on and off manually or in a pro-
grammed way (with the Timer function active).
Fig. 30
004778391 - 23/09/2021