User 9 Stove Operation; Stove Operation; Starting The Stove; Modifying The Parameters - Royal IDRO Notice D'installation

9 STOVE OPERATION

9.1 STARTING THE STOVE

To start the stove hold the
7KH ÀDPH LFRQ ZLOO VWDUW ÀDVKLQJ GXULQJ WKH LJQLWLRQ VWDJH XQWLO UHPDLQLQJ RQ VWHDG\ ZKHQ WKH VWRYH KDV VWDUWHG
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
WUDGLWLRQDO ¿UH OLJKWHUV
$YRLG OLJKWLQJ WKH ÀDPH PDQXDOO\ LI WKH VWRYH¶V DXWRPDWLF LJQLWLRQ V\VWHP LV QRW ZRUNLQJ FRUUHFWO\
:KHQ WKH VWRYH LV VWDUWHG WKH ¿UVW WLPH XQSOHDVDQW RGRXUV RU VPRNH PD\ EH JHQHUDWHG FDXVHG E\ HYDSRUDWLRQ
or drying of certain materials used. This phenomenon will gradually disappear.
7KH URRP VKRXOG EH ZHOO YHQWLODWHG ZKHQ VWDUWLQJ WKH VWRYH WKH ¿UVW IHZ WLPHV

9.2 MODIFYING THE PARAMETERS

7KH VWRYH RSHUDWLQJ SDUDPHWHUV FDQ EH PRGL¿HG DV GHVFULEHG LQ SDUDJUDSK 
7KH YDOXHV VHW ZLOO EH UHWDLQHG XQWLO QH[W PRGL¿HG HYHQ ZKHQ WKH VWRYH LV VZLWFKHG RII RU XQSOXJJHG IURP WKH
power supply.

9.3 SWITCHING OFF

To switch the stove off hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched off following the procedure described above. Never switch the stove off by
unplugging it from the power supply.

9.4 OPERATION WITH ROOM THERMOSTAT

When the stove is controlled by an external thermostat (or timer thermostat), the installer must have set
FRQ¿JXUDWLRQ 
,Q WKLV FRQ¿JXUDWLRQ WKH VWRYH VZLWFKHV RII ZKHQ UHDFKLQJ WKH H[WHUQDO WKHUPRVWDW VHWWLQJ RU DOWHUQDWLYHO\ PRGXODWHV
output (that is, the stove attempts to maintain the desired temperature while minimising fuel consumption) when
reaching the set water temperature.
The stove switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
2Q ¿UVW LJQLWLRQ RU LI WKH VWRYH KDV EHHQ VZLWFKHG RII PDQXDOO\
GLUHFWO\ IURP WKH FRQWURO SDQHO
The stove will go off automatically even in the case the water temperature keeps growing notwithstanding the modulation
mode. In this case the stove will ignite only if the difference between the selected and actual temperature is over 20°C.
7KHUHIRUH LI \RX FKRRVH WKLV FRQ¿JXUDWLRQ ZH VXJJHVW WKDW \RX VHOHFW D KLJK ZDWHU WHPSHUDWXUH HJ ƒ& 

9.5 OPERATION WITH ROOM PROBE ON THE BOILER

The boiler can be switched on/off manually or in programmed mode.
,Q WKLV W\SH RI FRQ¿JXUDWLRQ WKH ERLOHU PRGXODWHV RXWSXW DFFRUGLQJ WR WKH URRP WHPSHUDWXUH UHDG E\ WKH SUREH RQ
the boiler (that is, the boiler attempts to maintain the desired temperature while minimising fuel consumption).
If the user has enabled the "Eco-mode" function under submenu
rather than modulating its output, switches off when reaching the set temperature, and switches on again
when the room temperature falls below the delta set in submenu
The desired room temperature can be set in temperature menu
[6]
Submenu of the setup menu
for the heating system in question should be suggested by the heating system installer).

9.6 OPERATION IN COMBINATION WITH A STORAGE TANK

)RU RSHUDWLRQ LQ FRPELQDWLRQ ZLWK D VWRUDJH WDQN WKH LQVWDOOHU ZLOO KDYH VHW FRQ¿JXUDWLRQ  RU  GHSHQGLQJ RQ
whether the storage tank is with or without a coil inside.
The boiler is controlled based on the temperature read by the probe in the storage tank.
When reaching the storage tank temperature set in the temperature menu
switches on again if the temperature falls below the delta set in submenu
7KH IURVW SURWHFWLRQ IXQFWLRQ FDQ DOVR EH VHW LQ WKLV FRQ¿JXUDWLRQ
48/136
USE AND & MAINTENANCE
button for several seconds.
EXWWRQ IRU D IHZ VHFRQGV WKH ÀDPH LFRQ ZLOO VZLWFK RII
can be used to set the desired water outlet temperature (the best temperature
button), the stove needs to be started
[7]
of the setup menu
[7]
of the setup menu
.
the boiler switches off, and
[8]
of the setup menu
cod. 004772131 - 07/2013 - Royal
, the boiler
.
.