WALTHER PILOT TERRA Mode D'emploi page 11

Contents
Exploded Drawing
Declaration of CE-Conformity
Replacement parts
1 General
1.1 Model identification
1.2 Intended use
1.3 Inappropriate use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General Safety instructions
4 Supply line connection
5 Operational Handling
6 Spray pattern adjustments
6.1 Correcting spray pattern flaws
7 Troubleshooting and fault rectification
8 Conversion and repair
9 Cleaning
10 Waste disposal
11 Technical Data
2
21
22
24
24
24
25
25
25
25
26
27
27
28
29
29
30
31
32
32
20
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole respon-
sibility that the product(s) described below conform to the essential safety require-
ments. This declaration will be rendered invalid if any changes are made to the equip-
ment without prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Manual Spray Guns PILOT TERRA
PILOT TERRA
PILOT TERRA
PILOT TERRA-LVLP
PILOT TERRA-LVLP
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
EN 1127-1
Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006 / 42 / EC.
Wuppertal, the 1st of April 2014
p.p.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safe-
ty instructions provided in the product documentation must be observed at all times.
Gravity-Feed Cup V 11 801
Material Connection V 11 802
Gravity-Feed Cup V 11 811
Material Connection V 11 812
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 6
2417
21