Troubleshooting - Omron SpotArm i-Q132 Mode D'emploi

HEM-1010-E_[D].book 41 ページ ２０１１年１１月１５日 火曜日 午後７時３５分
4.2

Troubleshooting

Problem
The reading is
extremely high (or low).
Cuff is not inflated.
The unit operates normally and measurements
appear to be taken, but...
• Measurements taken by a doctor are higher (or
lower).
• Measurement results are different each time.
Power is turned off
during measurement.
The date and time are
reset.
The backlight does not
light.
Cause
Is your arm placed
through the arm cuff
correctly?
Talking during the
measurement.
Are rolled up sleeves
squeezing the arm?
Is the cuff lining in the
arm cuff damaged?
Is air leaking from the
arm cuff?
The batteries are empty.
The AC adapter is not
connected.
4. Handling Errors and Problems
Remedy
Refer to Chapter 3.2.
Keep quiet during
measurement.
Carefully read and repeat
the steps listed under
Chapter 3.3.
Carefully read and repeat
the steps listed under
Chapter 3.3.
Cancel the measurement
and contact your
OMRON distributor or
Customer Services.
Contact your OMRON
distributor or Customer
Services.
Refer to Chapter 7.
Replace the batteries.
(Refer to Chapter 2.1.)
The backlight does not
light when using only the
batteries.
Connect the AC adapter.
(Refer to Chapter 2.2.)
41
EN