SMC Networks EZ Connect Guide D'installation Rapide page 8

6. Wireless Bridge configuration: If you are connecting to an
existing wireless network, select [Infrastructure] and enter
the SSID of your network.
7. Now you will be asked to configure the Network Settings.
If you are connecting to a network with a DHCP server,
select [Use DHCP server] and click [NEXT]. If you do not
have a DHCP server on your network, input a static IP
address and click [NEXT].
13
8. If you have enabled Wired Equivalent Privacy (WEP) or Wi-Fi
Protected Access (WPA) on your wireless network, please
enter the private security key settings now. Select the drop
down menus of [Security Mode] to choose between WEP and
WPA. Select the drop down menus of [Key Length] to choose
between 64 or 128-bit encryption.
9. Finally, please verify all the settings you have entered.
If any configuration changes still need to be made, please
click [BACK] and make them now. Otherwise, click [NEXT]
to make the settings take effect. This will take a few seconds.
Please go to Step 14.
14