SMC Networks EZ Connect Guide D'installation Rapide page 74

13. Kontroller til sidst alle de oplysninger, du har indtastet. Hvis
du skal foretage flere konfigurationsændringer, skal du klikke
på [BACK] (TILBAGE) og foretage dem nu. Ellers skal du klikke
på [NEXT] (NÆSTE), så indstillingerne træder i kraft.
14. Nu er du færdig med konfigurationen. Du kan nu begynde at
bruge din EZ Connect™ g Wireless Ethernet Bridge.
145
Compliances
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
146