Setup Of The Image Sector - Eneo CANDID C-05 Notice D'emploi

6 Setup of the Image Sector

• Pull off the middle section of the camera housing (see fig. 1).
• Power up the camera and connect a monitor.
• Open locking screw 2 (see fig. 6). Turn the ring to adjust the zoom setting.
• Focus is adjusted by turning ring 1.
• Tighten both locking screws 1+2 when adjustment is done.
NOTE: For a precise adjustment of cameras installed outside it is recommended to place a ND (Neutral Density) filter in front of the lens while settings are
done. This opens up the iris and allows a setting which is constant at changing light conditions due to the narrower depth of field.
Fig. 6
Focus ring (manual)
1
Focal length adjustment (manual)
2
18