Function Switchers; Positions And Functions Of The Control Elements; Setting Of The Dip Switchers - Eneo CANDID C-05 Notice D'emploi

5. Function Switchers

5.1 Positions and functions of the Control Elements

Lens select switch
Switch must be set on DC position.
Video output BNC connector
1.0Vp-p/75ohms composite video signal is provided at this connector.
Iris level adjustment VR for DC drive lens
This potentiometer is used only if the camera is fitted with a DC drive auto iris lens. It is used to control the amount of light striking the CCD image sensor. Turn CW to
increase or CCW to decrease the brightness.
This VR functions properly under the following condition:
• ESC/ALC switch –> ALC
• Lens select switch –> DC
DC drive auto iris lens is installed.
Power input terminal (screw terminal)
12VDC is supplied through this terminal (recommended power supply: min. 180mA

5.2 Setting of the DIP Switchers

SW 1: ALC / ESC (Default: ESC)
Used to select iris control mode.
Not needed because of the firmly inserted lens !
SW 2: BLC ON/OFF (Default: ON)
If the subject you wish to view is to dim because of a bright background, set the BLC switch to ON to compensate for the bright background. With BLC ON, the back-
ground brightness may saturate in some cases. This function may not operate properly if the object is too small compared to the area of the background. This function
can be used with either the linear shutter (DSS or ELC mode).
SW 3: Flickerless ON/OFF (Default: OFF)
Under Flickerless ON mode, shutter is fixed to 1/120sec.
Flickerless mode is useful in areas where AC mains is 50Hz and TV systems is NTSC such like Japan or AC is 60Hz and TV system is PAL to reduce the flicker under
the florescent lights. When FL is set to ON, the low light sensitivity is down about 30%.
SW 4: Day-Night (ICR+DSS) ON/OFF (Default: ON)
If set to ON, camera enables both of day-night functions (ICR & DSS) and performs its functions in sequence in accordance with the scene illumination.
If the light level of the scene goes down under the 1
At 1 stage of D/N mode, camera outputs the real time B/W video and can accept IR light.
st
If the light level becomes lower than 2
sec(fastest) to 2 frames/sec (slowest) in accordance with the light level.
In case the light level increases, camera exits DSS and then ICR by returning its IR cut filter and switching to colour mode.
If set to OFF, camera operates just like a normal colour camera.
st threshold, camera enters D/N mode by removing its IR cut filter and switching to B/W mode.
threshold, camera enters DSS mode and outputs the field integrated video. The frame refresh rate varies from 32 frames/
nd
(1) Lens holder
(2) C mount adaptor
(3) Lens connector
(4) Lens select switch
(5) Video output BNC
(6) Iris level VR
(7) Power input terminal
(8) Function switch
17