ZANKER KOB10301XB Notice D'utilisation page 22

Cleaning the door gasket
• Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do not
use the appliance if the door gasket is damaged.
Contact the Service Centre.
• To clean the door gasket refer to the general infor-
mation about the cleaning.
Oven lamp
Warning! Be careful when you change the oven
lamp. Always switch off the appliance before you
start to replace the lamp. There is a risk of electric
shock.
Warning! Bulb lamps used in this appliance are
special lamps for use only in household
appliances. Do not use them to illuminate household
rooms or parts of rooms. If you need to replace a lamp,
the replacement lamp must have the same power and
be for use only in household appliances.
Before you change the oven lamp:
• Deactivate the appliance.
• Remove the fuses in the fuse box or deactivate the
circuit breaker.
• Put a cloth on the bottom of the oven. This prevents
from damage to the oven light and glass cover.
Replacing the oven lamp:
1. Find the lamp glass cover at the back of the cavi-
ty.
Turn the lamp glass cover counterclockwise to re-
move it.
2. Clean the glass cover.
3. Replace the oven lamp with an applicable 300 °C
heat-resistant oven lamp.
Use only the same oven lamp type as the replace-
ment lamp. It must have the same power and be
for use only in household appliances.
4. Install the glass cover.
Cleaning the oven door
The oven door has two panels of glass. You can re-
move the oven door and the internal panel of glass to
clean it.
The oven door can close if you try to remove the
internal panel of glass before you remove the
oven door.
22
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
5
Release the locking
system to remove the in-
ternal panel of glass.
2
1
7
Carefully lift (step 1)
and remove (step 2) the
panel of glass.
2
Lift and turn the lev-
ers on the two hinges.
4
Put the door on a soft
cloth on a stable surface.
90°
6
Turn the two fasten-
ers by 90° and remove
them from their seats.