Table des Matières
Publicité
Brady Network Card Compliance and Approvals
Indicaciones de seguridad
FCC Radiation Exposure Statement:
La radiación de la FCC Declaración de exposición:
FCC Part 15 Verification and Certification Statement
Parte 15 de las FCC, Declaración de verificación
FCC Class B Notice
viii
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Este equipamiento cumple con los límites de exposición a la radiación de la FCC que se
establecen para un entorno no controlado. Este equipo debe ser instalado y operado con un
mínimo de 20 cm de distancia entre el radiador y su cuerpo.
Este transmisor no debe estar colocado o funcionando en conjunto con otra antena o transmisor.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Este dispositivo cumple con la Parte 15 de las Reglas FCC. El funcionamiento está sujeto a estas dos
condiciones: (1) Este dispositivo puede no causar interferencia perjudicial y (2) este dispositivo
puede aceptar cualquier interferencia que reciba, incluso interferencias que pueden causar un
funcionamiento no deseado.
Note
: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult a dealer or an experienced radio/television technician for help.
FCC Caution
: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
®
33 Imprimante de signes et d'étiquettes Manuel d'utilisation
BBP
Publicité
Table des Matières
