Table des Matières
Publicité
r Mode selection key
Press this button to enter one of the following modes.
z Pattern selection mode:
Press the Up
or Down
number of the desired stitch appears on the LED
display.
x Stitch width adjusting mode:
Press the Up
key to increase the stitch width or
Down
key to decrease.
NOTE:
You can adjust the stitch width while the machine is
running.
c Stitch length adjusting mode:
Press the Up
key to increase the stitch length or
Down
key to decrease.
NOTE:
You can adjust the stitch length while the machine is
running.
t Direct pattern selection
The following four patterns can be directly selected by
pressing the corresponding key.
#01 Straight stitch
#07 Zigzag stitch
#09 Serging stitch
#16 Sensor buttonhole
key until the pattern
r
z
x
c
t
12
r
t
Publicité
Table des Matières
