Cleaning Hook Race And Feed Dog; Bobbin Holder - Janome 8048 Manuel D'instructions

Cleaning Hook Race and Feed Dog

WARNING:
Raise the presser foot and needle, and then unplug
the machine.
DO NOT dismantle the machine other than as
explained in this section.
z Remove the needle and presser foot.
q Screwdriver
w Setscrew
e Needle plate
x Remove the setscrew and needle plate.
c Take out the bobbin and bobbin holder.
v Clean the bobbin holder with the lint brush and soft
dry cloth.
r Bobbin holder
b Brush out dust and lint from the feed dog and clean
the hook race with the lint brush.
n Wipe inside of the hook race with a dry cloth.
NOTE:
You may use vacuum cleaner.
m Replacing Bobbin Holder and Needle Plate
, Insert the bobbin holder.
Make sure to fit the knob next to the stopper in the
hook race.
t Guide pins
y Stopper
u Knob
. Insert the bobbin and attach the needle plate
aligning the holes with the guide pins.
i Holes
⁄0 Tighten the setscrew firmly.
o Setscrew
NOTE:
After cleaning the machine, attach the needle and
presser foot.
z
q
w
x c
v
r
b
n
t
m ,
. ⁄0
o
70
e
y
u
i