Tensioning The Chain - PROPAIN TRICKSHOT Instructions De Montage

// TENSIONING THE CHAIN

1
Loosen the axle nuts and the fi xing screws of the dropouts.
3
Tighten the nuts of the axle with 18 Nm. Then tighten the
fi xing screws of the dropouts with 8-9 Nm.
2
Then turn the adjustment screws in or out equally on both sides until the
chain is slightly under tension. Check the tension of the chain, it should
be possible to push it down about 1 cm with your fi nger in the middle
between the crank and the rear axle.
Make sure the adjustment screws are screwed in and out evenly so that
the rear wheel is centered in the frame.