System Cleaning Programs - Panasonic HL-SX485S Mode D'emploi & Instructions D'installation

System Cleaning Programs

F1. DRAIN WATER
Water is pumped through the system to clean the pipes. The water is drained into the
drain tank.
Add 200 g of water to the
water tank.
NOTE
„ Only run this program with 200 g of water in the tank.
„ Do not remove the drain tank during the drain water program. If the drain tank is
removed during the program, 'INSERT DRAIN TANK' is displayed and the
program will stop.
„ Empty the drain tank and rinse with running water after the program has finished.
CAUTION
If the 'Drain water' program is used directly after a steam cooking program, hot water
may be drained into the drain tank.
F2. SYSTEM CLEANING
The first stage of this program cleans the system with a citric acid solution. The second
stage runs water through the system to rinse the pipes.
Make a solution of 8 g citric
acid and 200 g of water, add
the solution to the water tank.
Touch Stop/Start. The
program will run for
29 mins.
NOTE
„ When
„ If the system cleaning program is not used regularly, the pipe will get blocked and
the steaming performance will be less effective.
„ Do not remove the drain tank during the system cleaning program. If the drain
tank is removed during the program, 'INSERT DRAIN TANK' is displayed and the
program will stop.
„ Empty both tanks and rinse with running water after the program has finished.
Touch system Select "F1
cleaning key. DRAIN WATER".
Touch system
cleaning key.
After the program has paused,
empty the drain tank. Rinse the
water tank and re-fill with 200 g
of water.
blinks in the display, run the 'system cleaning' program.
Remove, empty
and re-insert
drain tank
before touching
Stop/Start.
Empty the drain tank after
the program has finished.
Remove, empty
and re-insert
drain tank
before touching
Stop/Start.
Select "F2
SYSTEM
CLEANING".
Touch Stop/Start. The program
will run for approx. 1 min.
Empty the drain tank after the
program has finished.
53
EN