Publicité
Les langues disponibles
Les langues disponibles
during operation. Do not touch hot
surfaces.
Hold the container only by its handle.
Th e appliance may only be used with the
original accessory parts provided by the
manufacturer.
Th e appliance must always be set on a fi rm,
level surface.
Do not allow the appliance or its power
cord to come into contact with open
fl ames or any hot surfaces such as hot-
plates.
Do not allow the power cord to hang free;
the cord must be kept well away from hot
parts of the appliance.
Always remove the plug from the wall
socket
- in case of any malfunction,
- aft er use,
- to turn the appliance off completely,
- before cleaning the appliance.
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Th is appliance is intended for domestic or
similar applications, such as in
- staff
kitchens,
commercial environments,
- agricultural areas,
- hotels,
motels
establishments,
- bed-and-breakfast guest houses.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by
qualifi ed
personnel,
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
Th e address can be found in the appendix
to this manual.
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
910025 de-en-fr-nl ma 2014
offi ces
and
other
etc.
and
similar
including
the
Before the appliance is used for the fi rst
time, or aft er extended periods of non-use, it
should be thoroughly cleaned as described in
the section General Care and Cleaning.
Operation
We recommend the use of long-life low-
fat milk (UTF, 1.5% fat content). For best
results, the milk should be taken from the
refrigerator immediately before frothing.
Th e underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
– Use the smooth stirring head to heat up
milk.
– For frothing and heating milk at the same
time, use the serrated head.
– For cold-frothing milk, also use the
serrated head.
– During periods of non-use, the stirring
heads may be safely stored at the rear of
the housing.
Fill amounts
– Always observe the minimum mark and
ensure the container is fi lled with at least
100 ml milk.
– For frothing, fi ll the container to a
maximum of 260 ml (lower max mark
– For heating, fi ll the container to a
maximum of 560 ml (upper max mark
).
Heating up or hot-frothing milk
1.
Place the container onto the base.
2.
Remove the lid from the milk container.
3.
Place the appropriate head onto the
mounting protrusion inside the bottom
of the container.
4.
Put the required amount of milk into
the container.
5.
Place the lid on the container.
6.
Insert the plug into a suitable wall
socket. A beep-signal is heard and the
main indicator lamp fl ashes.
).
8/18
Publicité
