Publicité
Les langues disponibles
Les langues disponibles
7.
Press the On/Off switch.
8.
A double beep-signal is heard, the main
indicator lamp shows a steady light
and the motor cooling system of the
appliance is heard to start up.
A moment later, the appliance starts
to heat up and stir the milk. Once the
milk is suffi ciently hot, the heating and
stirring process stops automatically. Th e
main indicator lamp starts fl ashing and
a number of beep-signals are heard.
9.
You can now remove the milk container
from the base. Use a suitable spoon to
take off the milk froth.
Th e cooling system continues to run for
a brief period. Th e main indicator lamp
stops fl ashing aft er about 3 minutes.
Remarks
If the appliance has not been disconnected
from the mains , the On/Off switch must be
pressed twice to start a new operating cycle.
Aft er a heating-up cycle, the appliance
cannot start a new stirring and heating
cycle immediately, but must be allowed to
cool down fi rst.
Cold-frothing of milk
You can also froth the milk without heating
it up fi rst.
1.
Follow the steps 1 to 6 as described in
the section 'Heating up or hot-frothing
milk.'
2.
Press and hold the On/Off switch for
about 2 seconds, until three beep-
signals are heard.
Th e main indicator lamp shows a steady
light and the motor cooling system is
heard to start up.
A moment later, the appliance starts to
stir the milk.
Th e stirring process stops automatically
aft er 1 minute.
A number of beep-signals are heard and
the main indicator lamp starts fl ashing.
3.
You can now remove the milk container
from the base.
Th e cooling system continues to run for
910025 de-en-fr-nl ma 2014
a brief period.
Th e main indicator lamp stops fl ashing
aft er about 3 minutes.
Aft er a cold-frothing cycle, a new stirring and
heating cycle may be started immediately.
Interrupting or ending a cycle
Press the On/Off switch to stop the heating
and stirring process: Th e main indicator
lamp starts fl ashing and the motor cooling
system can be heard.
To continue the heating and stirring process,
Press the On/Off switch again.
Switching the appliance off
Remove the plug from the wall outlet to turn
the appliance off completely.
Hint
To achieve a thicker froth, go through a
cold-frothing cycle fi rst, followed by a hot-
frothing cycle.
General Care and Cleaning
Always remove the plug from the wall
socket and wait until the motor has come
to a complete standstill before cleaning
the appliance.
To avoid the risk of electric shock, do not
clean the base or the power cord with
water and do not immerse them.
Th e container, stirring heads and lid may
be cleaned with hot water and a little
detergent. Th e attachment parts are also
dishwasher-safe.
– Wipe all parts thoroughly dry.
– Th e base may be cleaned with a damp
cloth and a little detergent.
Do not use abrasives or harsh cleaning
solutions.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
9/18
Publicité
