Installation; Installing The Remote Control; Choose A Location - OERTLI OETRONIC 4 Notice D'installation, D'utilisation Et D'entretien

RS400 - Package AD257
2

Installation

2.1

Installing the remote control

23/04/2009 - 300020550-001-A
200
8800N036-B
3
4
A000850-A
5
A000854-A
2.1.1.

Choose a location

Choose a location in a "reference" room representative of the room
temperature to be taken into account if the remote control is used as
a room sensor.
Locations in the room that are not recommanded:
Enclosed, exposed to solar radiation, heated by a flue duct, exposed
to cold or hot air currents from air ducts, close to an open fireplace, a
heat source (television), behind a curtain.
2.1.2. Installing the remote control
1. Drill 2 holes with a Ø of 6 mm.
2. Put the plugs in place.
3. Tighten the 2 screws.
4. Connect either a 2-wire telephone cable or an electrical cable with
a cross-section of up to 2x1.5 mm² to the 2-pin connector. The
wires can be interchanged.
5. Installing the remote control.
2. Installation
4