SilverCrest HG01041A Instructions D'utilisation Et Consignes De Sécurité page 14

CAUTION! Use the above-indicated battery types only. Failure to
observe this advice may result in damage to the product.
Receiver:
Remove the battery compartment cover
device.
Remove the used batteries, if present.
Insert 2 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment
Transmitter:
Remove the holder
Open the battery compartment
cover anticlockwise.
Insert a battery (3 V
face upwards.
Place the battery compartment cover on the battery compartment
and tighten it by turning it clockwise.
Fasten the holder
12 GB/IE/NI
, type AA).
.
9
from the back of the transmitter.
14
, type CR 2032). The side marked "+" must
of the receiver back on to the back of the device.
14
from the back of the
8
.
9
by turning the battery compartment
13
13