Publicité
Mounting the Bar
Use spacer bar (either 3/8" or 1/4") to
position dovetail/boxjoint bar. Position
dovetail/boxjoint bar so that the space
between the bar and the bit is equal to
the bit and bar width (either 3/8" or
1/4"). For easiest measuring, use the
spacer bars provided as a measuring
device.
SPACER
BAR
BIT
DOVETAIL/
BOXJOINT
BAR
1. Place spacer bar on router table with
edge touching outside diameter of
(3/8" or 1/4") router bit. See Figure
44.
2. Line up dovetail/box joint bar edge on
opposite side of spacer bar.
3. Secure each end of dovetail/box joint
bar by inserting a pan head screw
(BD) through hole and securing with a
hex nut (BE). See Figure 45.
Making Standard Dovetail
Joints and Box Joints
1. Assemble dovetail/box joint bar to
table as instructed above.
2. Select two pieces of wood of the
same thickness.
3. Adjust router so that the bit height
exactly matches the height of one
piece of wood laid horizontally. If you
Figure 44
wish to sand joint flush after
assembly, set cutter slightly deeper.
Securely tighten the router bit.
4. Offset the two pieces of wood 1/2"
and clamp them together. See Figure
46.
39
BD
BE
CLAMP
1/2" OFFSET
WOLF109-49
Figure 45
Figure 46
Publicité
Chapitres
