Publicité
ASSEMBLY
NOTE: While most instructions are
common to both units, some instructions
apply to either Model 6155 (floor-
standing) OR Model 6156 (benchtop).
Tools Required
#2 and #3 Phillips Screwdrivers
Hammer
Adjustable Wrench
Assemble Metal Miter Guide
(5° Increments, Model 6155 Only)
AF, zinc (1)
AH, black (1)
1. Assemble miter guide by threading
pan head screw (AF) into miter guide
head (H) through miter bar (K) and by
threading carriage bolt (AG) through
miter bar (K). See Figure 1.
2. Place washer (AH) and knob (M) on
end of carriage bolt (AG). Tighten
knob.
AG, black (1)
AJ, zinc (1)
H
N
K
3. Attach miter pointer (L) to miter bar
(K) with Phillips head screw (AJ).
4. Slide clamp (N) into one of two slots
on front of miter gauge.
12
M
AH
AG
AF
Figure 1
AJ
L
Publicité
Chapitres
