Publicité
When router table is
WARNING
not in use, always:
1. Place the switch box in OFF position
and remove the safety key.
2. Place router power switch in OFF
position.
3. Unplug switch box from wall outlet.
4. Remove router bit.
ASSEMBLING FENCE TO THE ROUTER TABLE
1. Place the fence on the router table
with the front of the fence (flat side)
facing the front of the router table.
See Figure 30.
2. Insert knob screw into the hole in the
tabletop and through the nut (AM) in
the fence guide mounted to the
underside of the table. Repeat for
other knob.
3. Turn knobs clockwise to secure fence
in desired position.
5. Make sure router collet assembly is
below router table.
6. Remove and place safety key in a
secure location. Remember where you
place the safety key.
If the breaker trips, the
WARNING
router stalls, or the power
fails for any other reason, place the
switch box in the OFF position, remove
the safety key, and unplug the switch box
from the wall outlet.
AM
30
O N
P U LL
FF
H O
P U S
E T
R E S
E T
S
T L
O U
Figure 30
Publicité
Chapitres
