Screwdriver Safety Warnings; Functional Description; Depth Adjustment - Makita FS2500 Manuel D'instruction

SCREWDRIVER SAFETY
WARNINGS
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. If you use this
power tool unsafely or incorrectly, you can suffer
serious personal injury.
1. Hold power
surfaces, when performing an operation where
the fastener may contact hidden wiring or its
own cord. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
tool by insulated
GEB017-3

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.

Depth adjustment

gripping
1
010107
The depth can be adjusted by turning the lock ring. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the lock ring equals 1.5 mm
(1/16") change in depth.
Adjust the lock ring so that the distance between the tip
of the locator and the screw head is approximately 1 mm
(3/64") as shown in the figures. Drive a trial screw into
your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue
adjusting until you obtain the proper depth setting.
1mm (3/64")
USD201-2
010152
Switch action
010114
4
A
B
1
1
2
1. Locking ring
1. Locator
1. Switch trigger
2. Lock button