Cordless Screwdriver Safety Warnings - Makita DFS452 Manuel D'instructions

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Switch trigger
5 Lock button
6 Mode indicator
SPECIFICATIONS
Capacities
No load speed
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
7 Lamp
8 Battery indicator
9 Indicator lamps
10 Check button
11 Reversing switch lever
12 Locator
Model
Self drilling screw
Drywall screw
With short locator
With long locator
Net weight
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF / DC18SH / DC18WC
ENE033-1
CORDLESS SCREWDRIVER SAFETY
WARNINGS
GEA010-2
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the fastener
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not
immediately after operation; they may be
extremely hot and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
7. Make sure there are no electrical cables,
waterpipes, gas pipes etc. that could cause a
hazard if damaged by use of the tool.
SAVE THESE INSTRUCTIONS.
13 Hook
14 Bit
15 Magnetic bit holder
16 Groove
17 Screw
DFS452
6 mm
5 mm
–1
0 – 4,000 min
235 mm
251 mm
1.5 – 1.8 kg
D.C. 18 V
may contact
touch the bit or
GEB139-2
hidden wiring.
the workpiece