Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
It is forbidden to use the device near flammable or combustible elements and objects or in similar
conditions. Soldering iron tips have very high temperatures, do not touch these elements! This can
cause serious burns.
3.
Too high temperature of the soldering iron may be the cause of reduction of the functionality of the
soldering tips.
4.
Soldering iron tip must be cleaned regularly using sponge and plate on a layer of tin to prevent tips
oxidation.
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING IRON HEATING
CORE ELEMENT
Before heater / soldering iron tip replacement make sure that the soldering iron is
completely cold.
1.
Unscrew the screws from the cover (1), then remove cover (1).
2.
Unsolder the wires of the heater (5) from plate (2), and unscrew the screws of the heater (5).
3.
Remove the heater (5) from the protective cover (4) and remove the soldering tip (6) from the hea-
ter (5).
4.
Replace the heater with new one, solder the wires and fix all in reverse order.
REGULAR CLEANING
Generalities
•
Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other
type of cleaning utensil that could damage the surface of the appliance.
•
Before cleaning you must remove the electricity supply plug isolating the appliance from the main
power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case, please contact your
customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latest is to be found on the technical plate on the device).
•
If relevant, a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. Avoid formulations like "the device doesn´t heat",
which may mean that it doesn´t heat enough or even not at all. These two possibilities have a different
causation!
•
The more detailed your information, the better the customer service will be able to answer your
problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a
loss of warranty!
10
EN
1.
cover
2.
pcb plate
3.
plastic insulating head
4.
protective cover of heater
5.
heater
6.
soldering tip
PL
DE
11
Publicité
Table des Matières
