Assembling The Ilmo Wt Module With The Tube Fitted With The S Tubular Module; Wiring; Commissioning - SOMFY ilmo 50 S WT Notice D'installation

Installation guide
4.5 Assembling the ilmo WT module with the
tube fitted with the S tubular module
Fit the tube complete with S tubular module (D)
1)
to the end bracket (J).
Insert the connector (K) of the ilmo WT module
2)
(E) into the S tubular module (D).Screw the
connector (K) into the S tubular module (D).
Fit the tube complete with S tubular module (D)
3)
to the motor bracket (L).
Fit the stop ring (M).

5. Wiring

Turn off the power supply.
1)
Connect the motor according to the information
2)
in the table below:
a Blue
b Brown
c Black
d Yellow/green

6. Commissioning

Switch the power back on.
1)
Press the "Up" button at the control point:
-
►
►
Switch off the power.
2)
Reverse the brown wire and the black wire
-
connected to the control point.
Switch the power back on.
3)
Press the "Up" button to check the direction of
-
rotation.
erved. Copyright © 2008 - 2009 Somfy SAS. All rights reserved.
54273X03_ilmo50Swt.indb 39
230 V 50 Hz
Neutral (N)
Live, Direction 1
Live, direction 2
Earth ( )
If the roller shutter rises, the wiring is
correct and commissioning is finished.
If the roller shutter is lowered, go to the
next stage.
Cable
ilmo 50 S WT
1
D
2
E
D
K
3
M
L
1
OFF
2
b
a
N
c
d
l
1
ON
2
OFF
3
ON
J
D
a
b
c
d
39
5/02/09 17:29:07