Kit Contents; Installation; Assembling The Ilmo Wt Module - SOMFY ilmo 50 S WT Notice D'installation

Installation guide
2.3.2 Locks and rigid links
After having affixed the roller shutter to the roller
-
tube, check that when the roller shutter is in
the lower end limit position, the rigid link/bolt is
correctly positioned and that the first slat is verti-
cally between the runners (as per F). If neces-
sary, adjust the number of slates used to improve
the position of the bolt/rigid link when the roller
shutter is in the lower end limit position.
Always refer to the manufacturer's size and
-
weight charts and fitting recommendations for
the rigid links or locks to select those suited to
the roller shutter used.
Caution: Use at least 2 bolts or 2 rigid links to
attach the roller shutter to the roller tube.

3. Kit contents

The ilmo 50 S WT motor comprises two insepara-
ble components:
the s tubular module (D).
-
the ilmo WT module (E),
-

4. Installation

It is essential to follow the order of assembly given
in the guide.

4.1 Assembling the ilmo WT module

Caution! The adhesive supplied is for single use
only. Always use the adhesive supplied by Somfy.
The use of any other adhesive is forbidden.
Caution: If the roller shutter is not fitted with a
flange, it is necessary to use some means of atta-
chment, such as a rilsan collar, along with some
adhesive. The additional means of attachment
chosen must hold the ilmo WT module inside the
end piece regardless of the conditions of use of the
roller shutter.
Clean the inner face of the head rail end piece
1)
(F).
Remove the protector from the adhesive stuck
2)
to the ilmo WT module (E).
Affix the ilmo WT module (E) to the head rail end
3)
piece (F).
Recommended: Pass the power supply cable
through a cable grommet fixed in the headrail to
ensure the cable is not under strain..
erved. Copyright © 2008 - 2009 Somfy SAS. All rights reserved.
54273X03_ilmo50Swt.indb 37
ilmo 50 S WT
F
F
D
E
1 2
F
3
E
F
E
37
5/02/09 17:28:55