Opening The Cover; Camera/Lens Installation - Bosch UHI Série Manuel D'utilisation

60 en | Installation
5.5

Opening the cover

WARNING!
The heater will be HOT when in operation - DO NOT TOUCH.
Always switch heater OFF when working on the camera.
Open the cover by unlatching the three latches on the side of
the housing. See Figure 5.2. If the optional tamper-resistant
screws have been installed, use the supplied wrench to remove
the screws before opening the latches.
Figure 5.2 Unlatching the cover
5.6

Camera/Lens installation

1.
2.
3.
F.01U.167.418 | 3.0 | 2010.04
Remove the two screws holding the camera tray to the
housing. Remove tray from the housing.
If using the feed-through feature, refer to
Section 5.7.3 Feed-through Wiring.
For installation of zoom lens cameras:
– Attach the lens to the camera.
– Use the various 1/4-20 screws and appropriate 4 mm
and/or 9 mm spacers provided to mount the camera
and the lens to the camera tray. This camera tray is
already pre-installed.
Installation Manual
UHI/UHO Series
Bosch Security Systems, Inc.