Video Coax Connection - Bosch UHI Série Manuel D'utilisation

68 en | Installation
Drawing layout and installation wiring diagram is in accordance
with the NEC, ANSI/NFPA 70 for indicating recommended
locations and wiring methods.
CAUTION!
For security protection of the device, the branch circuit
protection must be secured with a maximum fuse rating of 16A.
This must be in accordance with NEC 800 (CEC Section 60).
5.
6.
5.8

Video coax connection

See Table 4.3 and Table 4.4 for UHO-HBPS-10, UHO-HPS-50 and
UHO-HBPS-50 models.
1.
CAUTION!
Use only cables meeting specifications in Section 5.3 Cable
requirements for wiring video coax connections.
2.
3.
CAUTION!
Always securely tighten all fittings to ensure a liquid-tight seal.
Failure to do so could allow water to enter the housing and
damage the camera and lens. If a sealant is used, be sure it is a
neutral cure type. Sealants that release acetic acid may harm
camera electronics. Use of drip loops is recommended on the
wiring outside of the rear end cap.
F.01U.167.418 | 3.0 | 2010.04
On heater and heater/blower units, make sure the heater
and fan wires stay connected to the terminal block.
Make sure the BNC cable is separated from the Mains
power and heater.
Install a 1/2-inch NPT fitting into the available hole in the
rear cap.
Route the video coax cable through one of the fittings
installed in Step 1, or one of the feed-through fittings in the
base.
Attach the BNC connector to the coax and connect it to the
camera.
Installation Manual
UHI/UHO Series
Bosch Security Systems, Inc.