Installing The Housing; Opening The Cover; Feed-Through Wiring; Npt Fittings - Bosch UHI-SBG-0 Manuel D'installation

Table des Matières

Les langues disponibles

UHI-SBG-0 Series

Installing the Housing

This chapter outlines the procedures needed to install the UHI-SBG-0 Indoor Housing Series.

Installation should be made by a qualified service person and all local codes should be con-

formed to.

5.1

The UHI-SBG-0 housing is secured with two (2) tamper-resistant screws. To open the cover,

use the supplied tamper-resistant wrench (948002-00-00 M3.5 T20) to remove the screws.

Fig. 5.1 Opening the Cover

5.2

The UHI-SBG-0 features feed-through wiring holes which are used to feed the cabling through.

Prior to mounting the camera, remove the rear (2) or bottom (2) rubber dome plugs and

install the NPT fittings (see Section 5.3: NPT Fittings).

5.3

The NPT fittings ensure a tight seal. Depending on how the UHI-SBG-0 is mounted, the NPT fit-

tings can be installed either in the rear or from the bottom of the housing. The supplied 3/8 in.

NPT fittings accept a round cable with diameters from 4.3 mm (0.17 in.) to 11.4 mm (0.45 in.).

The two larger 1/2 in. NPT fittings accept cables with diameters from 6.5 mm (0.26 in.) to

10.5 mm (0.42 in.).

Fig. 5.2 Installing the NPT Fittings

Fig. 5.3 NPT Exploded View

Bosch Security Systems, Inc.

Screw Nut (discard if using 3/8 in. NPT for bottom openings)

Rubber Washer

NPT Fitting

Sealing Nut

Installation Manual

Installing the Housing | en

September 15, 2006 | F01U032279_01

Table des Matières